Pipeline System is one of the world's leading manufacturer of induction bends.

Indukční ohýbání je jednoduše aplikace tepla na konvenční trubku nebo potrubí a formování přesného požadovaného tvaru. Dokážeme vyrobit přesně ten kus, který potřebujete, s použitím materiálu dle výběru zákazníka, včetně bimetalových slitin odolných proti korozi. Large diameter and heavy wall production is also available. This process is performed per ISO 15590-1 and ASME B16.49.


Materiál: ROZHRANÍ API 5L, A106, A333, A335, A312, bi-metal alloys.

Velikosti Tolerance
FROM: 2" do 60" -1 ~+2 mm
Poloměr ohybu: R^3D
WT: 3 do 60 mm
WT thinning: R=3D <13%
R=4D <11%
R=5D <9%
R=6D <8%
Úhel ohybu: 0~180 deg ±0.5 deg
Forming velocity: ±2.5mm per min
Forming temperature: ±10°C from the qualification temp.
Bend ovality: <2.5%
Tangent ovality: <0.8%
ID welding ends NPS<36" ±2.5mm
ID welding ends NPS>36" ±3 mm
R = Radius • D = Diameter • OD = Outside Diameter • ID = Inside Diameter


Use of induction bending is especially beneficial where laminar flow is desired. This technology can replace most elbows and fittings used in traditional designs.


Flow Improvement: The manufacturing process adds no welds to the material, eliminating additional resistance found in traditional elbows. Proper material, diameter and radius selection further reducing resistance and achieving smoother flows and reducing wear within the induction bend products.

síla: Induction Bends are stronger than traditional elbows and fittings. Wall thicknesses are uniform.

Cost Effectiveness: Straight material processed with our technology is almost always less expensive and available faster than traditional components. The durability of our products will allow you to maintain less inventory of fittings and elbows.


TECHNOLOGIE: We utilize the most advanced equipment available. Temperatures are closely controlled, resulting in finish consistency providing consistent strength and hardness. We are able to maintain the geometric plane within 3mm. We guarantee back arc thinning superior to the competition.

životního prostředí: Our processes do not require the use of oils or lubricants in the forming process. Dále, all of our cooling water is reclaimed and reused. We consider and mitigate the environmental impact of all of our manufacturing processes.